WPC display Problems

From: “Lloyd Olson” <>
Newsgroups: rec.games.pinball
Subject: Re: WPC Display went out…

Power off, open up the backbox, check that all the connectors are on tight
on all the boards. Your opening and closing may have loosened something.

Then look over the area in general, make sure the grounding straps and
anything else back there isn’t pushing up against boards and shorting
things.

If you still have DMD problems, try reseating the ribbon cables for it from
the cpu, to the DMD driver board, to the DMD.

If super charger is still out, start checking fuses, power off remove and
check with an ohm meter. LTG :)